Applicable to any cuts except step cuts

The pavilion depth at girdle minima is measured using lower girdle facets. It is measured for each lower girdle facet and then the average, minimum, maximum and deviation values are calculated. The software finds the lowest vertex of the whole model (it is one the vertices of the culet or pavilion) and the highest vertex of each lower girdle facet. The depth between the found vertices is considered to be the pavilion depth at girdle minima for the given lower girdle facet, as shown on the figure below.

Comprehensive list of the Helium report parameters:

• Position normalization
• Diameters, Width & Length
• Main diameters
• Ratio (L/W) & Girdle Ratio
• Table
• Culet
• Total height
• Crown height
• Pavilion depth
• Upper and lower girdle facets' heights
• Crown height at girdle minima
• Pavilion depth at girdle minima
• Depth and length girdle facets
• Girdle thickness
• Girdle types for cushion as red, yellow, green and blue
• Corner angle width and Corner angle length
• Facets' slope and azimuth angle
• Facets' slope and azimuth angle for rounded fancies (obsolete)
• Azimuths deviation from ideal
• MIC & Girdle to MIC
• Girdle-Table offset (by table axis),
  Girdle-Culet offset (by table axis),
  Table-Culet offset (by table axis)
• Crown painting and Pavilion painting
• Girdle type (obsolete)
• Trapezium parameters
• Extra Facet / Natural
• Twist
• Statistical values

Measurements are used in different systems and tools:

• Lower girdle facets or halves
• OctoNus spread & AGS spread